Ross makes high speed dispersers for large scale production
Ross manufactures a full range of High Speed Dispersers suitable for high-volume mixing in vessels up to 6,000 gallons or larger. These production-scale High Speed Dispersers are either tank-mounted or supplied with an air/oil hydraulic lift. In the latter configuration, a height limit switch enables the mixer to operate from the fully down position to a safe raised height. This allows the operator to adjust blade position as necessary to eliminate any potential stratification within a large batch as well as agitate smaller liquid volumes during the initial stages of mixing. Shown is a 100HP High Speed Disperser designed for mounting on a mezzanine and equipped with a two-position swivel-lock assembly. At the end of a mixing cycle, the disperser is raised out of the tank and rotated 90 degrees to service another vessel while the first tank is drained and set-up for the next run.
Used for wetting out powders, creating a uniform suspension and general liquid-liquid mixing, the classic saw-tooth open disc blade of the Ross High Speed Disperser turns at tip speeds up to around 5000 feet per minute. It generates a vortex on the liquid surface into which solids and other minor components are added for quick incorporation. Satisfactory flow patterns and rapid turnovers are achieved in dispersions and solutions with a viscosity of >50,000 centipoise.
To speak with a mixing specialist about your application or to learn more about our trial/rental program and no-charge mixing demonstration services, call 1-800-243-ROSS today. For more information, visit www.mixers.com.